thanks for fixing 'show'
my excuse is that I wasn't completely napping, but meant to make this work: show pin x y z
and forgot that I did half of the worl
jepler: you have cat(s), right? or is that just cradek?
jmkasunich: I have a couple too
seen this: http://www.nanceestar.com/CatHaiku.html
some of those sure are true
New rule tomorrow.
jmkasunich: is this 3-phase stuff for your spindle?
You're always typing
Well, let's see you ignore my
Sitting on your hands.
a little premature - I have lots to do before I get there
^^ just got done with an episode of this, in fact
they also like to read - but only papers that you are reading
and they read by standing on them
hahah "can I fit my head inside your armpit"
Cats have no handles.
re: washing one
SWPadnos_ is now known as SWPLaptop
SWPLaptop is now known as SWPadnos_
darn -- gcodemodule doesn't call any python code for START_SPEED_FEED_SYNCH
you're that far already?
jepler: isn't there a html version of the ngc document on linuxcnc.org?
(one with the images in it)
I couldn't find the link...
I don't think there's a link :(
alex_joni: I don't think there is a need for a link. That kind of old info could easily confuse newcomers. I would suggest it be labeled clearly as old info, or completely removed.
unfortunately not all that information is in new documentation, and even when it is the HTML version often has big problems like missing images
jepler: I wonder what that old html was built with
awallin: I don't plan to link to it..
it's there for historical reasons only
the g-code quick reference links into handbook/RS274NGC_3 rather than the new HTML docs
fjungclaus___ is now known as fjungclaus