Back
[02:10:40] <dmwaters> {global notice} Good day folks, we have some maintenence about to happen to 2 rotation servers. These boxes have been out of rotation for a while but we'll still lose some users.
[08:27:57] <sebjames> Think I found the key to allowing homing in mdi and auto mode. In command.c there is test for being in coord mode, and if so, break is called. That emans joint->home_state is never set to HOME_START
[08:28:10] <sebjames> That's emc/motion/command.c
[08:36:53] <sebjames> That got me further, but now I'm coming up against the fact that the homing feature really _is_ coded with the free trajectory planner in mind...
[08:41:27] <sebjames> Yes.. All the logic in control.c is based on being in free mode :(
[08:45:23] <sebjames> I think I might give up and try the probe command, even though it's not that nice.
[08:45:36] <sebjames> I mean for homing...
[15:46:51] <jepler> aha, here's the realtime usb project that hasn't disappeared yet:
http://svn.berlios.de/wsvn/usb4rt/trunk/usb4rt/?rev=0&sc=0
[15:47:28] <jepler> it appears to support one kind of host chipset (uhci) and one device (ftdi serial)
[20:26:24] <jepler> alex_joni: do you have a .png or other not-lossy-compression version of the linuxcnc.org banner?
[20:26:55] <jepler> specifically the "penguin and end mill" part of
http://www.linuxcnc.org/templates/linuxcnc/images/linuxCNC_06_3.jpg
[20:27:44] <alex_joni> jepler: not atm
[20:27:50] <jepler> alex_joni: OK, oh well
[20:27:54] <alex_joni> gotta run.. my time expires in about 2 minutes
[20:28:01] <cradek> bye
[20:28:06] <alex_joni> I'll check it sometime in the weekend I hope
[20:29:02] <jepler> see you
[20:29:17] <alex_joni> I hava a .psd
[20:29:25] <jepler> I wonder if gimp loads those
[21:22:21] <rayh> I don't seem to be able to checkout from cvs from here?
[21:23:00] <rayh> sh-3.00$ cvs -z9 -d:ext:anon@cvs.linuxcnc.org/cvs co -d emc2-puresim emc2
[21:23:00] <rayh> connect to address 206.222.212.221: No route to host
[21:23:21] <rayh> but I can ping cvs.linuxcnc.org
[21:23:31] <rayh> any clues in that?
[21:30:13] <rayh> Ah part my fault. Needed export command
[21:30:41] <rayh> I think there should be a :/cvs in that command line in the wiki page for pure sim.
[22:35:47] <cradek> rayh: export CVS_RSH=ssh
[22:38:21] <cradek> oh I see he figured it out, I didn't read far enough
[22:38:27] <cradek> ... and, he isn't here now
[22:38:35] <cradek> * cradek goes back under his rock
